-
ARDUINO
- RASPBERRY
- MICRO:BIT
- KITS
-
COMPONENTES
-
Resistências Elétricas
- Kit de Resistências
- Resistências 1% 125mW
- Resistencias 1% 250mW
- Resistencias 1% 500mW
- Resistencias 1% 600mW
- Resistências 1% 1W
- Resistencias 1% 2W
- Resistências 5% 125mW
- Resistencias 5% 250mW
- Resistencias 5% 500mW
- Resistências 5% 1W
- Resistencias 5% 2W
- Resistencias 5% 3W
- Resistências Potência
- Resistências Várias
- Redes Resistencias
- Termistores
- Trimmers
- Trimmers 3296
- Joysticks
- Botões
- Potenciometro slider
- Potenciometros Rotativos
- Potenciometro Multivolta
- Potenciometros Motorizados
- MODULOS
- SENSORES
- ROBÓTICA
- IMPRESSÃO 3D
-
FERRAMENTAS
Ferramenta Eletronica
- Acessórios
- Analisador Logico
- Alicates para Eletronica
- Berbequins
- Caixas Arrumação
- Chaves de Precisão
- Chaves Ajuste
- Extensões
- Fita Isoladora
- Fonte de Alimentação
- kit Ferramentas
- Lupa Eletronica
- Aparelhos de Medida, Multímetros e Outros
- Osciloscopios
- Pinças para Eletrónica
- Pontas de Prova
- Material Soldadura
- Spray de Limpeza
- Tornos e Suportes
- PROMOÇÕES
- BLOG
Português
EUR €
Ramps 1.4 Endstop Switch For RepRap 3D Printer | Impressora 3D with 70cm Cable
Ramps 1.4 Endstop Switch For RepRap 3D Printer with 70cm Cable
Descrição
Ramps 1.4 Endstop Switch For RepRap 3D Printer with 70cm Cable
Description:
It uses 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage.
An insulating layer over a wide range of temperatures, up to 80 degrees.
The common connection of thin copper wire can not match.
Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one. You can use the direct plug
Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Cable Length: Approx. 70 cm / 27.56 inch
Connection Description:
Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Verde Line connection SIGNAL (ramps in s)
Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.
Package Included:
1 x 3D Printer Endstop Switch
1 x 70cm cable