131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens
131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion) | Motor DC com Engrenagens

131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion)

131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion)

Motor 131:1 37x57mm

PTR007391
45,39 €
Com IVA

Descrição

131:1 Metal Gearmotor 37Dx57L mm (Helical Pinion)

This gearmotor is a powerful brushed DC motor with 131.25:1 metal gearbox intended for operation at 12 V. The gearbox is composed mainly of spur gears, but it features helical gears for the first stage for reduced noise and improved efficiency. These units have a 16 mm-long, 6 mm-diameter D-shaped output shaft.

Key Specifications:

voltageno-load performancestall extrapolation
12 V 76 RPM, 150 mA 45 kg⋅cm (630 oz⋅in), 5.5 A

Note: Stalling or overloading gearmotors can greatly decrease their lifetimes and even result in immediate damage. In order to avoid damaging the gearbox, we recommend keeping continuously applied loads under 10 kg-cm (150 oz-in), and the recommended upper limit for instantaneous torque is 25 kg-cm (350 oz-in). Stalls can also result in rapid (potentially on the order of seconds) thermal damage to the motor windings and brushes; a general recommendation for brushed DC motor operation is 25% or less of the stall current.

These motors are intended for use at 12 V, though in general, these kinds of motors can run at voltages above and below the nominal voltage (they can begin rotating at voltages as low as 1 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.

Dimensions:

This diagram is also available as a downloadable PDF (461k pdf).

Warning: Do not screw too far into the mounting holes as the screws can hit the gears. We recommend screwing no more than 3mm (0.12″) into the screw hole.

Tradução em Português brevemente disponível!

Detalhes do produtos

Clientes que compraram este produto também compraram:

Produto adicionado a lista de desejos

Ao continuares a navegar estás a consentir a utilização de cookies que possibilitam a apresentação de serviços e ofertas adaptadas aos teus interesses. Poderá consultar no seguinte link a nossa Politica de Cookies