100:1 Metal Gearmotor 37Dx57L mm (Helical Pinion)

100:1 Metal Gearmotor 37Dx57L mm (Helical Pinion)

This gearmotor is a powerful brushed DC motor with 102.08:1 metal gearbox intended for operation at 12 V. The gearbox is composed mainly of spur gears, but it features helical gears for the first stage for reduced noise and improved efficiency. These units have a 16 mm-long, 6 mm-diameter D-shaped output shaft. 

Key specifications:

voltage: 12V

No load performance:100 RPM, 150 mA 

stall extrapolation: 34 kg⋅cm (470 oz⋅in), 5.5 A

Note: Stalling or overloading gearmotors can greatly decrease their lifetimes and even result in immediate damage. In order to avoid damaging the gearbox, we recommend keeping continuously applied loads under 10 kg-cm (150 oz-in), and the recommended upper limit for instantaneous torque is 25 kg-cm (350 oz-in). Stalls can also result in rapid (potentially on the order of seconds) thermal damage to the motor windings and brushes; a general recommendation for brushed DC motor operation is 25% or less of the stall current.

These motors are intended for use at 12 V, though in general, these kinds of motors can run at voltages above and below the nominal voltage (they can begin rotating at voltages as low as 1 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.

Tradução em Português brevemente disponível!