PICkit 3 Microcontroller Programmer

PTR001433
Não há produtos suficientes em stock
72,02 €
Com IVA

PICkit 3 Microcontroller Programmer

Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.

PICkit 3 Microcontroller Programmer

Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer. In-circuit debugging offers these benefits:

    Low cost
    Minimum of additional hardware needed for debug
    Expensive sockets or adapters are not required

The MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming™.

PICkit 3 Features

    USB (Full speed 12 Mbits/s interface to host PC)
    Real-time execution
    MPLAB IDE compatible (free copy included)
    Built-in over-voltage/short circuit monitor
    Firmware upgradeable from PC/web download
    Totally enclosed
    Supports low voltage to 2.0 volts (2.0v to 6.0v range)
    Diagnostic LEDs (power, busy, error)
    Read/write program and data memory of microcontroller
    Erase of program memory space with verification
    Freeze-peripherals at breakpoint
    Program up to 512K byte flash with the Programmer-to-Go

Header Information

Some 8-, 14- and 18-pin devices use small header boards with a special MCU for debugging. This special MCU has extra pins for PICkit 3 communication and therefore allows the use of all pins on the part for the application. The header board is not used or needed for programming. However, when debugging these devices the header must be used. See the "Header Specification" document below or see a list of current devices that use headers.

No reviews

Clientes que compraram este produto também compraram:

Produto adicionado a lista de desejos
Produto adicionado para comparar

Ao continuares a navegar estás a consentir a utilização de cookies que possibilitam a apresentação de serviços e ofertas adaptadas aos teus interesses. Poderá consultar no seguinte link a nossa Politica de Cookies