Relay Shield v3.0
The Relay Shield utilizes four high quality relays and provides NO/NC interfaces that control the load of high current. Which means it could be a nice solution for controlling devices that couldn’t be directly controlled by Arduino’s Digital I/Os. Standardized shield form factor enables smoothly connection with the Arduino. The shield also has four dynamic indicators show the on/off state of each relay.
Features:
- Arduino/Seeeduino compatible
- Standardized shape design
- Working status indicators for each relay
- High quality relays
- Provides NO/NC interfaces
Specification:
CHANNEL1 Interface:
COM1- Common pin
NC1- Normally Closed. Will be connected with COM1 when RELAY1 pin is set low and disconnected when RELAY1 is high;
NO1- Normally Open. Will be connected with COM1 when RELAY 1 pin is set high and disconnected when RELAY1 is low;
4 Digital Pins to control 4 Relays: RELAY1-RELAY4 pins could be connected directly with Arduino pin number of 7-4, so that four relays could be easily controlled by the Arduino
Documents:
Please visit our
wiki page for more info about this product. It will be appreciated if you can help us improve the documents, add more demo code or tutorials. For technical support, please post your questions to our
forum.
Technical details:
- Dimensions: 100mm x67mm x30mm
- Weight: G.W 77g
- Battery: Excluded
- Operating Voltage: 4.75V~5.25V
- Operating Current: 8~250 mA
- Switching Voltage: 250VAC/30VDC
- Switching Current: 15A/7A
- Frequency: 1Hz
- Switching Power: 70W
- Relay Life: 100,000 Cycle
- ESD contact discharge: ±4KV
- ESD air discharge: ±8
- Dimension: 68.7 x 53.5 x 30.8 mm
- Net Weight: 55±2 g
