Módulo WiFi Bluetooth ESP32 LoRa SX1276 868-915MHz c/ Display OLED 0.96"
Informação do fabricante:
WIFI Kit series is the new development of the cost-effective networking program, the main chip using ESP32, LX6 dual-core processor, computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 Wi-Fi transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluetooth (traditional Bluetooth and BLE low power Bluetooth).
This product is based on the WIFI Kit 32 added SX1276 chip, that is, LoRa ™ remote modem, Applicable frequency:868MHz -915MHz frequency, about -148dBm high sensitivity, +20 dBm power output, high reliability, transmission distance (measured open area communication distance 2.6Km).
Onboard 32MByte Flash, Wi-Fi antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface, CP2102 USB to serial chip, the perfect support for Arduino development environment, can be very simple and fast for program verification and product development.
Technical Parameters:
- Flash: 32M-Bits
- Processor: for Tensilica LX6 Dual Core
- Master chip: ESP32
- LoRa chip: SX1276
- Support frequency band: 868-915MHZ
- Open communication distance: 2.8KM
- Computing capacity: up to 600DMIPS
- Dual-mode Bluetooth: traditional Bluetooth and BLE low-power Bluetooth
- Development environment: perfect support for Arduino
- Operating voltage: 3.3-7V
- Operating temperature range: -40-90 Celsius
- Receiver sensitivity: -139dBm (SF12, 125KHZ)
- UDP continuous throughput: 135Mbps
- USB adapter chip: CP2102
- Support mode: Sniffer, Station, softAP and Wi-Fi Direct
- Transmit power: 19.5dBm@11b, 16.5dBm@11g, 15.5dBm@11n
- Data rate: 150Mbps @ 11n HT40, 72Mbps @ 11n HT20,
- 54Mbps @ 11g, 11Mbps @ 11b
- U.FL IPEX to SMA Connector Antenna 868-915MHz for Lora Board Lora32u4 II Wifi Lora32
- Connector type: ipex
- Band definition: 868-915MHz
- Standing wave ratio: <=1.5
- Gain: 3dBi
- Maximum power: 10W
- Input impedance: 50 ohm
- colour:black
- Material:Metal + PC
- size:Display: 0.96 inch
Package Contents:
- ESP32 Lora OLED development board
- Pin header
- Pin header stickers
- U.FL IPEX to SMA Connector Antenna
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.