30:1 Micro Metal Gearmotor
30:1 Micro Metal Gearmotor
This gearmotor is a miniature (0.94" x 0.39" x 0.47"), low-current brushed DC motor with 30:1 metal gearbox, similar to Sanyo’s popular 12 mm gearmotors. These units have a 0.365"-long, 3 mm-diameter D-shaped output shaft.
30:1 Micro Metal GearmotorThis gearmotor is a miniature (0.94" x 0.39" x 0.47"), low-current brushed DC motor with 30:1 metal gearbox, similar to Sanyo’s popular 12 mm gearmotors. These units have a 0.365"-long, 3 mm-diameter D-shaped output shaft.
Key specs at 6 V: 440 RPM and 40 mA free-run, 4 oz-in (0.3 kg-cm) and 0.36 A stall.
These tiny brushed DC gearmotors are intended for use at 6 V, though in general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range (rotation can start at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and offer a choice between two different motors: high-power (HP) and standard. With the exception of the 1000:1 gear ratio versions, all of the micro metal gearmotors have the same physical dimensions, so one version can be easily swapped for another if your design requirements change. Please see the micro metal gearmotor comparison table for detailed specifications of all our micro metal gearmotors. This dynamically-sortable table can help you find the gearmotor that offers the best blend of speed, torque, and current-draw for your particular application.
Detalhes do produtos
Clientes que compraram este produto também compraram:
Magnetic Encoder Pair Kit for Micro Metal Gearmotors 12 CPR 2.7-18V (HPCB compatible)
Magnetic Encoder Pair Kit for Micro Metal Gearmotors 12 CPR 2.7-18V (HPCB compatible) This kit includes two dual-channel Hall Effect sensor boards and two 6-pole magnetic discs that can be used to add quadrature encoding to two micro metal gearmotors with extended back shafts (motors are not included with this kit).
Adafruit Perma-Proto Half-sized Breadboard PCB - Single
Adafruit Perma-Proto Half-sized Breadboard PCB - Single Customers have asked us to carry basic perf-board, but we never liked the look of most basic perf: its always crummy quality, with pads that flake off and no labeling.
Motor - Pontes H
2A Motor Shield For Arduino
2A Motor Shield For Arduino This DFRobot Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC motors with maximum 2A current. This shield can be directly mount onto standard Arduino Duemilanoveand Arduino Mega.