Módulo Temporizador para Iluminação Led 6-30V USB-C

Wide voltage power supply (6~30V) supports micro USB 5.0V power supply or TYPE-C interface power supply. Two interfaces can be selected;

The interface is clear and simple, with powerful functions;

With one button emergency stop function (STOP key), with reverse connection protection, reverse connection does not burn;

You can set different OP, CL, and LOP parameters, which are independent of each other and saved separately;

All set parameters are automatically saved after power down.

Product parameters:

1. Working voltage: 6-30V, supporting microUSB data 5.0V power supply

2. Trigger source: High level (3.0V-24V), with optocoupler isolation, which can improve the anti-interference ability of the system (customers can also short common points).

3. Output function: It can control DC 30VDC 5A or 5A 220VAC equipment.

4. Static current: 20 mA; Working current: 50mA

5. Service life: over 100000 times; Working temperature: - 40-85 ℃; Dimensions:

6: Optocoupler isolation, enhanced anti-interference ability, industrial grade motherboard.

Special note: The relay output is a passive contact, just a switch.

TYPE-C interface:

• Working voltage: 6-30V
• Support: TYPE-C 5.0V power supply
• Trigger signal source: High level trigger (3.0V-24V) signal ground and system ground are not in common to improve the anti-interference ability of the system (it can also be shorted to common ground by itself)
• Output capacity: It can control equipment within 30V5A DC or 220V5A AC
• Static current: 20mA Working current: 50mA
• Service life: more than 100000 times;
• Working temperature: - 40-85 ℃;
• With optocoupler isolation, enhanced anti-interference ability, industrial grade circuit board, set parameters for permanent power failure
• Memory.

Operating mode:

P1: After the signal is triggered, the relay turns on for OP time and then turns off; During the OP time, proceed as follows

P1.1: Signal triggered again invalid

P1.2: The signal triggers a retiming again

P1.3: The signal triggers reset again, the relay is disconnected, and the timing stops;

P-2: Give a trigger signal, and after the relay turns off CL time, the relay turns on OP time. After the timing is completed, turn off the relay;

P3.1: After the trigger signal is given and the relay is turned on for an OP time, the relay is turned off for a CL time, and then the above actions are cycled. If the signal is given again within the cycle, the relay is turned off and the timer is stopped; The number of cycles (LOP) can be set;

P3.2: After powering on, there is no need to trigger a signal, the relay turns on OP time, and the relay turns off CL time. Cycle the above actions; The number of cycles (LOP) can be set;

P-4: If there is a trigger signal for the signal holding function, the timer will be cleared and the relay will remain on; When the signal disappears, turn off the relay after timing OP; During the timing period, if there is another signal, the timing will be cleared;

Note:

1. Pay attention to the wiring as shown in the figure, and do not connect it incorrectly.

2. This document only represents the product parameters at the time of editing, and is subject to change without notice.

3. The relay output is a passive contact, which is not energized and controls the on-off of a line.

Timing range: 0.1 seconds (minimum) to 999 minutes (maximum) continuously adjustable

Package included:

1 x DC 5V 12V 24V LED Light Digital Time Delay 1 Way Relay Trigger Cycle Switch Circuit Board Type-C/Micro USB Timing Control Module